Pressing Instructions

ALL TRANSFERS MUST BE APPLIED WITH A HEAT PRESS!!! WE ARE NOT RESPONISBLE FOR TRANSFERS APPLIED INCORRECTLY.

SINGLE COLOR SCREEN PRINT TRANSFERS:

Heat: 325

Pre-Press For 7 Seconds

Press For 7 Seconds

Heavy Pressure 

Hot Peel

HIGH HEAT TRANSFERS

🚨 Full color transfers (will state on the title line HIGH HEAT)

Pre-press for 7 seconds

Heat: Start at 350 with HEAVY HEAVY pressure and increase the heat by 5 degrees each time if the print is not sticking and repress.

375 is manufacturer recommended temperature for 7 seconds, however we personally press at 365. Use more pressure than what you would use for the low heat transfers. If press is too hot, the screen will be faded. Do not cover with Teflon. We suggest  that you check to make sure your heat on your press is accurate with a heat gun.

SUBLIMATION TRANSFERS

Heat: 400

Press for 60 seconds with medium pressure

2. Place sheets of white copy paper or parchment paper inside your shirt to prevent bleed through. 

3. Check your transfer paper to make sure there is no extra ink on the paper. We recommend that you cut up to the design, all around the paper. If you see the ink, it will transfer to your shirt. 

4. Position your transfer face down ( use heat tape if desired) and cover with Teflon sheet. 

5. Press at settings given above. 

6. Remove transfer immediately

DIRECT TO FILM INSTRUCTIONS (DTF)

60LBS Pressure / COLD PEEL

Poly 275 Degrees/10 sec

Triblend 275 Degrees/10 sec

50/50 300 Degrees/12 sec

Cotton 325 Degrees/15 sec

*For Matte Finish: Repress with kraft paper for 10 seconds